| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172 |
- # SPDX-License-Identifier: GPL-2.0-only
- #
- # Solarflare device configuration
- #
- config NET_VENDOR_SOLARFLARE
- bool "Solarflare devices"
- default y
- help
- If you have a network (Ethernet) card belonging to this class, say Y.
- Note that the answer to this question doesn't directly affect the
- kernel: saying N will just cause the configurator to skip all
- the questions about Solarflare devices. If you say Y, you will be asked
- for your specific card in the following questions.
- if NET_VENDOR_SOLARFLARE
- config SFC
- tristate "Solarflare SFC9100/EF100-family support"
- depends on PCI
- depends on PTP_1588_CLOCK_OPTIONAL
- select MDIO
- select CRC32
- select NET_DEVLINK
- help
- This driver supports 10/40-gigabit Ethernet cards based on
- the Solarflare SFC9100-family controllers.
- It also supports 10/25/40/100-gigabit Ethernet cards based
- on the Solarflare EF100 networking IP in Xilinx FPGAs.
- To compile this driver as a module, choose M here. The module
- will be called sfc.
- config SFC_MTD
- bool "Solarflare SFC9100-family MTD support"
- depends on SFC && MTD && !(SFC=y && MTD=m)
- default y
- help
- This exposes the on-board flash and/or EEPROM as MTD devices
- (e.g. /dev/mtd1). This is required to update the firmware or
- the boot configuration under Linux.
- config SFC_MCDI_MON
- bool "Solarflare SFC9100-family hwmon support"
- depends on SFC && HWMON && !(SFC=y && HWMON=m)
- default y
- help
- This exposes the on-board firmware-managed sensors as a
- hardware monitor device.
- config SFC_SRIOV
- bool "Solarflare SFC9100-family SR-IOV support"
- depends on SFC && PCI_IOV
- depends on INET
- default y
- help
- This enables support for the Single Root I/O Virtualization
- features, allowing accelerated network performance in
- virtualized environments.
- config SFC_MCDI_LOGGING
- bool "Solarflare SFC9100-family MCDI logging support"
- depends on SFC
- default y
- help
- This enables support for tracing of MCDI (Management-Controller-to-
- Driver-Interface) commands and responses, allowing debugging of
- driver/firmware interaction. The tracing is actually enabled by
- a sysfs file 'mcdi_logging' under the PCI device.
- source "drivers/net/ethernet/sfc/falcon/Kconfig"
- source "drivers/net/ethernet/sfc/siena/Kconfig"
- endif # NET_VENDOR_SOLARFLARE
|
