| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566 |
- ***************************************************
- Xilinx ZCU102 / ZCU104 / ZCU106 boards - ZynqMP SoC
- ***************************************************
- This document describes the Buildroot support for the ZCU102, ZCU104
- and ZCU106 boards by Xilinx, based on the Zynq UltraScale+ MPSoC (aka
- ZynqMP). It has been tested with the ZCU102 and ZCU106 production
- boards.
- Evaluation board features can be found here with the links below.
- ZCU102:
- https://www.xilinx.com/products/boards-and-kits/zcu102.html
- ZCU104:
- https://www.xilinx.com/products/boards-and-kits/zcu104.html
- ZCU106:
- https://www.xilinx.com/products/boards-and-kits/zcu106.html
- How to build it
- ===============
- Configure Buildroot: (use the command for the specific board)
- $ make zynqmp_zcu102_defconfig
- $ make zynqmp_zcu104_defconfig
- $ make zynqmp_zcu106_defconfig
- Compile everything and build the rootfs image:
- $ make
- Result of the build
- -------------------
- After building, you should get a tree like this:
- output/images/
- +-- atf-uboot.ub
- +-- bl31.bin
- +-- boot.bin
- +-- boot.vfat
- +-- Image
- +-- rootfs.ext2
- +-- rootfs.ext4 -> rootfs.ext2
- +-- sdcard.img
- +-- system.dtb -> zynqmp-zcu106-revA.dtb
- +-- u-boot.itb
- `-- zynqmp-zcu106-revA.dtb
- How to write the SD card
- ========================
- WARNING! This will destroy all the card content. Use with care!
- The sdcard.img file is a complete bootable image ready to be written
- on the boot medium. To install it, simply copy the image to an SD
- card:
- # dd if=output/images/sdcard.img of=/dev/sdX
- Where 'sdX' is the device node of the SD.
- Eject the SD card, insert it in the board, and power it up.
|
